GSW: Texture Rolling Pin – Tank Tracks
Textured Rolling Pins capable of pressing a continuous repeated pattern on clay and putties. Made of clear PMMA plastic with amazing non-stick properties. Non-toxic. They come in several different textures that you can purchase based on your specific needs.
Basic Instructions:
- 1. Properly mix the putty/clay until ready according to the manufacturer.
- 2. Extend the putty/clay on a surface to be textured.
- 3. Depending on the type of putty/clay, it is advisable to wet the Rolling Pin.
- 4. Slowly move the Rolling Pin applying equal pressure at all points for an even texture.
- 5. Trim any excess putty/clay with a sharp knife.
Specifics:
- Pattern: Tank Tracks
- Length: 14.50 cm (5.5 inches)
- Diameter: 2.5cm (1 inch)
- Scale: 28–35mm
Tools & modelling equipment sold separate. Contents may vary from the box image.