TP-Link 10/100Mbps Multi-Mode Media Converter
The MC100CM is a media converter designed to convert 100BASE-FX fiber to 100Base-TX copper media or vice versa. Designed under IEEE 802.3u 10/100Base-TX and 100Base-FX standards, the MC100CM is designed for use with multi-mode fiber cable utilizing the SC-Type connector. The MC100CM supports longwave (LX) laser specification at a full wire speed forwarding rate. It works at 850nm on both transmitting and receiving data.
Other features of this module include the ability to be used as a stand alone device (no chassis required) or with TP-LINK´s 19´´system chassis, Auto MDI/MDI-X for TX port, Auto negotiation of duplex mode on TX port and front panel status LEDs. The MC100CM will transmit at extended fiber optic distances utilizing multi-mode fiber up to 2 kilometers.
- Complies with 802.3u 10/100Base-TX, 100Base-FX standards
- Link Fault Passthrough and Far End Fault minimize the loss caused by link failure timely
- Provides switch configuration of Half-Duplex / Full-Duplex transfer mode for FX port
- Extends fiber distance up to 2km
Specifications
MEDIA CONVERTER & MODULE
Standards and Protocols: IEEE 802.3, IEEE 802.3u, IEEE
802.3×
Basic Function
- Half/Full-Duplex transfer mode for FX port
- Full Duplex Flow Control (IEEE 802.3×)
- Half Duplex Flow Control (Backpressure)
- Extends fiber distance up to 2km
- Link Fault Passthrough and Far End Fault minimize the loss caused by link failure timely
Ports
- 1 100M SC port
- 1 100M RJ45 port (Auto MDI/MDIX)
Wave Length: 1310nm
Network Media 10BASE-T
- UTP category 3, 4, 5 cable (maximum 100m)
- EIA/TIA-568 100Ω STP (maximum 100m)
Network Media 100BASE-T
- UTP category 5, 5e cable (maximum 100m)
- EIA/TIA-568 100Ω STP (maximum 100m)
Network Media 100BASE-FX
- Multi-mode Fiber
LED Indicators: PWR, FDX/Col, Link/Act, SPD
Dimensions (WDH): 3.72.91.1 in.
(94.573.027.0 mm)