Here are some other products you might consider...
| 5 star |
|
(18) |
| 4 star |
|
(5) |
| 3 star |
|
(0) |
| 2 star |
|
(4) |
| 1 star |
|
(2) |
Very hard to squeeze the glue out the metal attachment piece. The old bottle they used to have was much easier. I won't buy this glue bottle again because it's hard to use. However, since writing this review the 1st time, I found by removing the needle like pin from the bottle that I am able to squeeze the glue through the small hole on the lid. When I'm not using the glue, I just put the needle back and close up.
I used to use & like Humbrol glue, but I don't know what they have done. This stuff is now is so thick you end up taking the whole lid off & scooping out with a tooth pick. It is not very user friendly.
I'm a fan of humbrol plastic cement in general but this stuff is awful. It is almost impossible to get the glue through the “precision” tube. And when you finally do get some out the nozzle it comes away in strands of glue that are a total bitch to clean off the piece being glued. Just stick to the standard poly cement.
A solvent-based cement suitable for plastic model kits only. It's viscosity is low to enable precision delivery of fine amounts of cement. The product works by melting the plastic on application and ‘welding’ two glued pieces of plastic together to form a strong bond.
Application: Directly onto plastic model kitsets.
The bottle lid features a very thin tube to deliver the product sparingly to small areas or fine details.
Drying Time: Surface dry in 10 – 20 minutes.
Full dry in 1 hour.
Drying times will vary according to ambient temperature and humidity.
There are no Marketplace listings available for this product currently.
Already own it? Create a free listing and pay just 9% commission when it sells!
